Back to Learning Center
Process

Arc Stud Welding Process

6 min readMay 2026

Arc stud welding is a fast welding process used to attach studs, anchors, and fasteners to steel. It is commonly used in construction, bridge work, high-rise buildings, embed plate production, industrial maintenance, and heavy fabrication.

How Arc Stud Welding Works

Arc stud welding uses a welding gun, power source, control system, cables, studs, and usually a ceramic ferrule. The process happens in a controlled sequence:

  • The stud is loaded into the gun
  • A ceramic ferrule is placed around the weld end of the stud when required
  • The gun is positioned against the base material
  • The trigger is pulled
  • The gun lifts the stud slightly off the base material
  • An arc is created between the stud and the base metal
  • The arc melts the end of the stud and the base material
  • The gun plunges the stud into the molten weld pool
  • The molten metal solidifies
  • The ferrule is broken away

What the Ferrule Does

The ceramic ferrule is an important part of many arc stud welds. Ferrules must be dry, undamaged, and matched to the stud size and application.

  • Contains the molten weld metal
  • Shields the weld area
  • Shapes the weld flash
  • Supports the weld pool
  • Improves consistency

Key Arc Stud Welding Variables

  • Stud diameter and material
  • Base material and thickness
  • Weld time and current / amperage
  • Lift and plunge
  • Ferrule type
  • Gun setup and cable size
  • Ground connection
  • Power source
  • Welding position
  • Surface condition

Common Arc Stud Types

  • Headed shear connector studs
  • Threaded studs
  • Deformed bar anchors
  • Concrete anchors
  • Tap pads
  • No-thread studs
  • Special weld studs

What a Good Weld Looks Like

A good arc stud weld typically has consistent weld flash around the base of the stud. The stud should be straight, fully attached, and free from obvious defects such as severe undercut, porosity, lack of fusion, or burn-through. Visual inspection is important, but project requirements may also call for bend testing, torque testing, pull testing, or other inspection methods.

Ready to Rent?

Put This Knowledge to Work

Every machine we rent is pre-calibrated to your stud specs before it ships. Get an exact quote for your next job.