Back to Learning Center
Applications

Through-Deck Stud Welding Checklist

5 min readMay 2026

Through-deck stud welding is commonly used on composite metal deck projects. The studs are welded through the metal deck and into the steel beam flange below. This checklist helps contractors prepare before production starts.

Before Welding: Confirm the Basics

  • Correct stud diameter and length
  • Correct ferrule
  • Correct stud count and beam locations
  • Correct drawings and sequence
  • Correct equipment for stud size
  • Correct generator or power source
  • Correct WPS if required

Before Welding: Check the Deck

  • Deck is tight to beam
  • Deck is not floating
  • Weld area is dry
  • Deck profile matches the ferrule/application
  • No excessive debris at weld location
  • No standing water
  • No improper coating at weld location

Before Welding: Check the Beam

  • Beam flange is suitable for welding
  • No heavy rust at weld location
  • No oil, grease, or moisture
  • No heavy paint or coating unless approved
  • Ground path is clean and secure

Before Welding: Check the Equipment

  • Proper welder capacity and cable size
  • Cable lugs tight and no damaged insulation
  • Good ground clamp
  • Gun lead in good condition
  • Control cable connected
  • Chucks and ferrule grips correct
  • Spare parts available

Before Welding: Check the Ferrules

  • Correct ferrule size
  • Ferrules are dry and not cracked
  • Ferrules match application
  • Ferrules are staged properly

During Welding: Watch For

  • Consistent weld flash
  • Studs standing straight
  • Clean ferrule break-off
  • No excessive spatter or porosity
  • No burn-through
  • No sudden change in weld sound or appearance

After Welding

  • Break ferrules away
  • Visually inspect studs
  • Perform required bend or other testing
  • Replace or repair failed studs as required
  • Keep documentation if the project requires it
  • Confirm completed areas before moving to the next sequence

Common Through-Deck Problems

  • Deck not tight to beam
  • Wet ferrules
  • Poor ground
  • Dirty beam flange
  • Incorrect settings
  • Wrong ferrule
  • Cable voltage drop
  • Gun not straight
  • Welding in wrong location

Ready to Rent?

Put This Knowledge to Work

Every machine we rent is pre-calibrated to your stud specs before it ships. Get an exact quote for your next job.