Back to Learning Center
Setup

How to Set Weld Parameters for Drawn Arc Studs

7 min readFebruary 2025

Getting your weld parameters dialed in correctly is the single most important factor in producing consistent, code-compliant drawn arc stud welds. This guide breaks down each parameter, what it controls, and how to set it for common structural stud sizes.

The Four Key Parameters

Every drawn arc stud welder has four adjustable parameters: weld time (duration of the arc), amperage (current level), lift (how far the stud is retracted to strike the arc), and plunge (how far the stud is driven into the melt pool). Each affects the final weld differently.

Weld Time

Weld time is measured in cycles (1 cycle = 1/60 second at 60Hz). For 3/4" headed studs, typical weld time is 35–45 cycles. Longer times increase heat input and weld pool size but risk burning through thin base materials. Too short and you get incomplete fusion.

Amperage

Amperage is the primary driver of arc energy. For 3/4" studs on 1/4" plate, a typical starting point is 1,400–1,600 amps. Always start at the lower end and bend test before increasing. Too much amperage causes flash blowout and undermines the ferrule.

Lift and Plunge

Lift controls how far the stud is pulled back before the arc strikes. Too little lift and the arc is unstable. Too much and you lose energy before the stud returns. Plunge controls how deep the stud drives into the melt pool — affects flash ring formation and weld height.

Starting Points by Stud Diameter

  • 1/2" stud: 800–1,000A, 25–30 cycles
  • 5/8" stud: 1,100–1,300A, 30–35 cycles
  • 3/4" stud: 1,400–1,600A, 35–45 cycles
  • 7/8" stud: 1,600–1,800A, 45–55 cycles
  • 1" stud: 1,800–2,200A, 55–65 cycles

Always Bend Test First

Never start production welding without bend testing at least 10 studs. Per AWS D1.1, bend studs 30° — a sound weld shows no cracking at the base. If you see cracking, adjust parameters and retest before proceeding.

Every machine we ship is pre-calibrated to your stud diameter, length, and base material — so you can start bend testing on arrival rather than spending the morning guessing at settings.

Ready to Rent?

Put This Knowledge to Work

Every machine we rent is pre-calibrated to your stud specs before it ships. Get an exact quote for your next job.